Skip to main content
Chemistry LibreTexts

3.2.4: Rate of Diffusion through a Solution

  • Page ID
    1414
  • Diffusion in a gas is the random motion of particles involved in the net movement of a substance from an area of high concentration to an area of low concentration. Each particle in a given gas continues to collide with other particles. In regions of the gas where the particle density is the highest, the particles bounce off each other and the boundary of their container at a greater rate than particles in less-dense regions.

    Introduction

    For a gas, the rate at which diffusion occurs is proportional to the square root of the density of the gas. The density of a gas is equal to the mass of the gas divided by the volume of the gas. If the volume is held constant one gas is compared with another with another,

    \(\dfrac{R_2}{R_1} = \sqrt{\dfrac{M_1}{M_2}}\)

    where R is the rate of diffusion in mol/s and M is the molar mass in g/mol. This is known as Graham's law of diffusion.

    Fick's First Law of Diffusion

    For a volume of solution that does not change:

    \[J = -D\dfrac{dc}{dx}\]

    • When two different particles end up near each other in solution, they may be trapped as a result of the particles surrounding them, which is known as the cage effect or solvent cage.

      Two different particles colliding may be represented as a 2nd order reaction: \(A + B \rightarrow AB\)

      \[AB = K_d[A][B]\]

      Notice the use of Kd to denote the diffusion rate constant.

      If circumstances change and either of the particles is able to diffuse out of the solvent cage, then the following 1st order reaction \(AB \rightarrow A + B\) is possible, then:

      \[AB = K_d'[AB]\]

      There now exists a reaction for the formation of the AB complex as well as the breakdown of the AB complex into products.

      \[k = \dfrac{K_aK_d}{K_a + K_d'}\]

      \(V = K[A][B]\)

      \[A + B \rightarrow AB \rightarrow Products\]

      The net rate of formation for AB can now be determined:

      \(\dfrac{d[AB]}{dt} = (A+B \rightarrow AB) - (AB \rightarrow A + B) - (AB \rightarrow Products)\)

      \[\dfrac{d[AB]}{dt} = K_d[A][B] - K_d'[AB] - K_a[AB]\]

      Assuming steady state conditions:

      \[\dfrac{d[AB]}{dt} = K_d[A][B] - K_d'[AB] - K_a[AB] = 0\]

      \([AB] = \dfrac{K_d[A][B]}{K_a + K_d'}\)

      The final rate of product formation taking into account both diffusion and activation:

      \(V = \dfrac{K_d[A][B]}{K_a + K_d'}\)

      Diffusion-controlled limit

      If the rate at which particle A encounters particle B is much slower than the rate at which AB dissociates, then Kd' is essentially zero.

      \(V = \dfrac{K_d[A][B]}{K_a}\)

      Activation-controlled limit

      The rate at which particle A encounters and reacts with particle B may exceed the rate at which the AB complex breaks apart into a product by a significant quantity. If the rate of at which AB decomposes is slow enough that Ka in the denominator may be ignored, the following results:

      \(V = \dfrac{K_d[A][B]}{K_d'}\)

      The Rate Constant Kd

      Viscosity and rate of diffusion may be related by the following formula:

      \(K_d = \dfrac{8RT}{3n}\)

      where n is the viscosity of the solution.

      Practice Problems

      1. Compare the rate of diffusion between fluorine and chlorine gases. Fluorine gas, F2, has a molecular mass of 32 grams. Chlorine gas, Cl2, has a molecular mass of 70.90 grams.
      2. Gas A is 0.75 times as fast as Gas B. The mass of Gas B is 32 grams. What is the mass of Gas A?
      3. Determine the rate of diffusion (flux) for aspirin dissolving through the stomach lining. C1= 50 mg/L and C2 = 290 mg/L. The diffusivity constant of aspirin is 0.29×10-9 cm2/s and the thickness of the stomach lining is approximately 0.5 cm.
      4. How long will it take oxygen to diffuse 0.5 cm below the surface of a still lake if D = 1×10-5cm2/s?
      5. If it takes 5 seconds for oxygen to diffuse to the center of a bacterial cell that is 0.02 cm in diameter, determine the diffusivity constant.

      Solutions to Practice Problems

      1. Using Graham's law of diffusion:

      (Rate1/Rate2) = (Mass2/Mass1)1/2

      (RateF2/RateCl2) = (70.9g/32g)1/2 = 1.49

      Fluorine gas is 1.49 times as fast as chlorine gas.

      2. Using Graham's law of diffusion:

      (Rate1/Rate2) = (Mass2/Mass1)1/2

      (RateA/RateB) = (MassB/MassA)1/2

      0.75 = (32g/MassA)1/2

      0.752=(32g/MassA)

      MassA = (32g/0.5625)

      MassA = 56.8888g

      3. Using Fick's first law:

      J = -D(dc/dx)

      Where:

      J = unknown flux

      D = 0.29×10-9 cm2/s

      dc = (C1 - C2) = 50mg/L - 290mg/L = -240mg/L, which is equivalent to -240mg/1000cm3 =-0.24mg/cm3

      dx = 0.5cm

      J = (0.29×10-9cm2/s)[(-0.24mg/cm3)/(0.5cm)] = 1.39×10-10mg/s×cm2

      J = 1.39×10-10mg/s×cm2

      4. Using Fick's second law:

      T = x2/2D

      Where:

      T = our unknown (time)

      x = 0.5 cm

      D = 1×10-5cm2/s

      T = (0.5cm)2/[2(1×10-5cm2/s)]

      T = 1.25×104 seconds

      5. Using Fick's second law:

      First, rearrange the equation T = x2/2D to solve for D --> D = x2/2T

      Where:

      D = our unknown (diffusivity constant)

      x = 0.01 cm (distance from the outside to the center of the cell)

      T = 5s

      D = (0.01cm)2/[2(5s)]

      D = 1×10-5cm2/s

      References

      1. Chang, Raymond. Physical Chemistry for the Biosciences. University Science Books, California 2005
      2. Atkins, Peter and de Paula, Julio. Physical Chemistry for the Life Sciences. W.H. Freeman and Company, New York 2005

      Contributors

      • Eric Stouffer (UCD), Anne Slisz (UCD)