1.4: Chemistry in Industry
Skills to Develop
 To recognize the SI base units and explain the system of prefixes used with them.
People who live in the United States measure weight in pounds, height in feet and inches, and a car’s speed in miles per hour. In contrast, chemistry and other branches of science use the International System of Units (also known as SI after Système Internationale d’Unités), which was established so that scientists around the world could communicate efficiently with each other. Many countries have also adopted SI units for everyday use as well. The United States is one of the few countries that has not.
Base SI Units
Base (or basic) units, are the fundamental units of SI. There are seven base units, which are listed in Table \(\PageIndex{1}\), Chemistry uses five of the base units: the mole for amount, the kilogram for mass, the meter for length, the second for time, and the kelvin for temperature. The degree Celsius (°C) is also commonly used for temperature. The numerical relationship between kelvins and degrees Celsius is as follows:
\[K = °C + 273 \label{Eq1}\]
Property  Unit  Abbreviation 

length  meter  m 
mass  kilogram  kg 
time  second  s 
amount  mole  mol 
temperature  kelvin  K 
electrical current  ampere  amp 
luminous intensity  candela  cd 
The United States uses the English (sometimes called Imperial) system of units for many quantities. Inches, feet, miles, gallons, pounds, and so forth, are all units connected with the English system of units. There have been many mistakes due to the improper conversion of units between the SI and English systems.
The size of each base unit is defined by international convention. For example, the kilogram is defined as the quantity of mass of a special metal cylinder kept in a vault in France (Figure \(\PageIndex{1}\)). The other base units have similar definitions. The sizes of the base units are not always convenient for all measurements. For example, a meter is a rather large unit for describing the width of something as narrow as human hair. Instead of reporting the diameter of hair as 0.00012 m or even 1.2 × 10^{−4} m, SI also provides a series of prefixes that can be attached to the units, creating units that are larger or smaller by powers of 10.
Figure \(\PageIndex{1}\): The Kilogram. The standard for the kilogram is a platinumiridium cylinder kept in a special vault in France. Source: Photo reproduced by permission of the Bureau International des Poids et Mesures, who retain full internationally protected copyright.
Common prefixes and their multiplicative factors are listed in Table \(\PageIndex{2}\). (Perhaps you have already noticed that the base unit kilogram is a combination of a prefix, kilo meaning 1,000 ×, and a unit of mass, the gram.) Some prefixes create a multiple of the original unit: 1 kilogram equals 1,000 grams, and 1 megameter equals 1,000,000 meters. Other prefixes create a fraction of the original unit. Thus, 1 centimeter equals 1/100 of a meter, 1 millimeter equals 1/1,000 of a meter, 1 microgram equals 1/1,000,000 of a gram, and so forth.
Prefix  Abbreviation  Multiplicative Factor  Multiplicative Factor in Scientific Notation 

giga  G  1,000,000,000 ×  10^{9} × 
mega  M  1,000,000 ×  10^{6} × 
kilo  k  1,000 ×  10^{3} × 
deca  D  10 ×  10^{1} × 
deci  d  1/10 ×  10^{−1} × 
centi  c  1/100 ×  10^{−2} × 
milli  m  1/1,000 ×  10^{−3} × 
micro  µ*  1/1,000,000 ×  10^{−6} × 
nano  n  1/1,000,000,000 ×  10^{−9} × 
*The letter µ is the Greek lowercase letter for m and is called “mu,” which is pronounced “myoo.” 
Both SI units and prefixes have abbreviations, and the combination of a prefix abbreviation with a base unit abbreviation gives the abbreviation for the modified unit. For example, kg is the abbreviation for kilogram. We will be using these abbreviations throughout this book.
What is the difference between “mass” and “weight”?
The mass of a body is a measure of its inertial property or how much matter it contains. The weight of a body is a measure of the force exerted on it by gravity or the force needed to support it. Gravity on earth gives a body a downward acceleration of about 9.8 m/s^{2}. In common parlance, weight is often used as a synonym for mass in weights and measures. For instance, the verb “to weigh” means “to determine the mass of” or “to have a mass of.” The incorrect use of weight in place of mass should be phased out, and the term mass used when mass is meant. The SI unit of mass is the kilogram (kg). In science and technology, the weight of a body in a particular reference frame is defined as the force that gives the body an acceleration equal to the local acceleration of free fall in that reference frame. Thus, the SI unit of the quantity weight defined in this way (force) is the newton (N).
Derived SI Units
Derived units are combinations of SI base units. Units can be multiplied and divided, just as numbers can be multiplied and divided. For example, the area of a square having a side of 2 cm is 2 cm × 2 cm, or 4 cm^{2} (read as “four centimeters squared” or “four square centimeters”). Notice that we have squared a length unit, the centimeter, to get a derived unit for area, the square centimeter.
Volume is an important quantity that uses a derived unit. Volume is the amount of space that a given substance occupies and is defined geometrically as length × width × height. Each distance can be expressed using the meter unit, so volume has the derived unit m × m × m, or m^{3} (read as “meters cubed” or “cubic meters”). A cubic meter is a rather large volume, so scientists typically express volumes in terms of 1/1,000 of a cubic meter. This unit has its own name—the liter (L). A liter is a little larger than 1 US quart in volume. (Table \(\PageIndex{3}\) gives approximate equivalents for some of the units used in chemistry.)
1 m ≈ 39.36 in. ≈ 3.28 ft ≈ 1.09 yd 
1 cm ≈ 2.54 in. 
1 km ≈ 0.62 mi 
1 kg ≈ 2.20 lb 
1 lb ≈ 454 g 
1 L ≈ 1.06 qt 
1 qt ≈ 0.946 L 
As shown in Figure \(\PageIndex{2}\), a liter is also 1,000 cm^{3}. By definition, there are 1,000 mL in 1 L, so 1 milliliter and 1 cubic centimeter represent the same volume.
\[1\; mL = 1\; cm^3 \label{Eq2}\]
Figure \(\PageIndex{2}\): The Liter. A liter is defined as a cube 10 cm (1/10th of a meter) on a side. A milliliter, 1/1,000th of a liter, is equal to 1 cubic centimeter.
Example \(\PageIndex{1}\)
Give the abbreviation for each unit and define the abbreviation in terms of the base unit.
 kiloliter
 microsecond
 decimeter
 nanogram
SOLUTION
 The abbreviation for a kiloliter is kL. Because kilo means “1,000 ×,” 1 kL equals 1,000 L.
 The abbreviation for microsecond is µs. Micro implies 1/1,000,000th of a unit, so 1 µs equals 0.000001 s.
 The abbreviation for decimeter is dm. Deci means 1/10th, so 1 dm equals 0.1 m.
 The abbreviation for nanogram is ng and equals 0.000000001 g.
Exercise \(\PageIndex{1}\)
Give the abbreviation for each unit and define the abbreviation in terms of the base unit.
 kilometer
 milligram
 nanosecond
 centiliter
Energy, another important quantity in chemistry, is the ability to perform work, such as moving a box of books from one side of a room to the other side. It has a derived unit of kg•m^{2}/s^{2}. (The dot between the kg and m units implies the units are multiplied together.) Because this combination is cumbersome, this collection of units is redefined as a joule (J). An older unit of energy, the calorie (cal), is also widely used. There are 4.184 J in 1 cal. All chemical processes occur with a simultaneous change in energy.
To Your Health: Energy and Food
The food in our diet provides the energy our bodies need to function properly. The energy contained in food could be expressed in joules or calories, which are the conventional units for energy, but the food industry prefers to use the kilocalorie and refers to it as the Calorie (with a capital C). The average daily energy requirement of an adult is about 2,000–2,500 Calories, which is 2,000,000–2,500,000 calories (with a lowercase c).
If we expend the same amount of energy that our food provides, our body weight remains stable. If we ingest more Calories from food than we expend, however, our bodies store the extra energy in highenergydensity compounds, such as fat, and we gain weight. On the other hand, if we expend more energy than we ingest, we lose weight. Other factors affect our weight as well—genetic, metabolic, behavioral, environmental, cultural factors—but dietary habits are among the most important.
In 2008 the US Centers for Disease Control and Prevention issued a report stating that 73% of Americans were either overweight or obese. More alarmingly, the report also noted that 19% of children aged 6–11 and 18% of adolescents aged 12–19 were overweight—numbers that had tripled over the preceding two decades. Two major reasons for this increase are excessive calorie consumption (especially in the form of highfat foods) and reduced physical activity. Partly because of that report, many restaurants and food companies are working to reduce the amounts of fat in foods and provide consumers with more healthy food options.
Density is defined as the mass of an object divided by its volume; it describes the amount of matter contained in a given amount of space.
\[\mathrm{density=\dfrac{mass}{volume}}\label{Eq3}\]
Thus, the units of density are the units of mass divided by the units of volume: g/cm^{3} or g/mL (for solids and liquids), g/L (for gases), kg/m^{3}, and so forth. For example, the density of water is about 1.00 g/cm^{3}, while the density of mercury is 13.6 g/mL. (Remember that 1 mL equals 1 cm^{3}.) Mercury is over 13 times as dense as water, meaning that it contains over 13 times the amount of matter in the same amount of space. The density of air at room temperature is about 1.3 g/L.
Example \(\PageIndex{2}\): Density of Bone
What is the density of a section of bone if a 25.3 cm^{3} sample has a mass of 27.8 g?
SOLUTION
Because density is defined as the mass of an object divided by its volume, we can set up the following relationship:
\[ \begin{align*} \mathrm{density} &=\dfrac{mass}{volume} \\[5pt] &= \dfrac{27.8\:g}{25.3\:cm^3} \\[5pt] &=1.10\:g/cm^3 \end{align*}\]
Note that we have limited our final answer to three significant figures.
Exercise \(\PageIndex{2}\): Density of Oxygen
What is the density of oxygen gas if a 15.0 L sample has a mass of 21.7 g?
Concept Review Exercises

What is the difference between a base unit and a derived unit? Give two examples of each type of unit.

Do units follow the same mathematical rules as numbers do? Give an example to support your answer.
Answers

Base units are the seven fundamental units of SI; derived units are constructed by making combinations of the base units; base units: kilograms and meters (answers will vary); derived units: grams per milliliter and joules (answers will vary).

yes; \(\mathrm{mL\times\dfrac{g}{mL}=g}\) (answers will vary)
Key Takeaways
 Recognize the SI base units.
 Combining prefixes with base units creates new units of larger or smaller sizes.