Skip to main content
Chemistry LibreTexts

13.3 Chemical Shifts

[ "article:topic", "showtoc:no" ]
  • Page ID
    67289
  • Objectives

    After completing this section, you should be able to

    1. describe the delta scale used in NMR spectroscopy.
    2. perform calculations based on the relationship between the delta value (in ppm), the observed chemical shift (in Hz), and the operating frequency of an NMR spectrometer (in Hz).

    Key Terms

    Make certain that you can define, and use in context, the key terms below.

    • chemical shift
    • delta scale
    • upfield/downfield

    Study Notes

    Although the calculations described in this section will help you understand the principles of NMR, it is the actual delta values, not the calculations, which are of greatest importance to the beginning organic chemist. Thus, we shall try to focus on the interpretation of NMR spectra, not the mathematical aspects of the technique.

    In Section 13.9 we discuss 1H NMR chemical shifts in more detail. Although you will eventually be expected to associate the approximate region of a 1H NMR spectrum with a particular type of proton, you are expected to use a general table of 1H NMR chemical shifts such as the one shown in Section 13.9.


    Chemical Shifts

    The NMR spectra is displayed as a plot of the applied radio frequency versus the absorption. The applied frequency increases from left to right, thus the left side of the plot is the low field, downfield or deshielded side and the right side of the plot is the high field, upfield or shielded side (see the figure below). The concept of shielding will be explained shortly.

    NMR spectra

    The position on the plot at which the nuclei absorbs is called the chemical shift. Since this has an arbitrary value a standard reference point must be used. The two most common standards are TMS (tetramethylsilane, (Si(CH3)4) which has been assigned a chemical shift of zero, and CDCl3 (deuterochloroform) which has a chemical shift of 7.26 for 1H NMR and 77 for 13C NMR.

    The scale is commonly expressed as parts per million (ppm) which is independent of the spectrometer frequency. The scale is the delta (δ) scale.

    delta scale

    The range at which most NMR absorptions occur is quite narrow. Almost all 1H absorptions occur downfield within 10 ppm of TMS. For 13C NMR almost all absorptions occurs within 220 ppm downfield of the C atom in TMS.

    Shielding in NMR

    Structural features of the molecule will have an effect on the exact magnitude of the magnetic field experienced by a particular nucleus. This means that H atoms which have different chemical environments will have different chemical shifts. This is what makes NMR so useful for structure determination in organic chemistry. There are three main features that will affect the shielding of the nucleus, electronegativity, magnetic anisotropy of π systems and hydrogen bonding.

    Electronegativity

    The electrons that surround the nucleus are in motion so they created their own electromagnetic field. This field opposes the the applied magnetic field and so reduces the field experienced by the nucleus. Thus the electrons are said to shield the nucleus. Since the magnetic field experienced at the nucleus defines the energy difference between spin states it also defines what the chemical shift will be for that nucleus. Electron with-drawing groups can decrease the electron density at the nucleus, deshielding the nucleus and result in a larger chemical shift. Compare the data in the table below.

     

    Compound, CH3X CH3F CH3OH CH3Cl CH3Br CH3I CH4 (CH3)4Si
    Electronegativity of X 4.0 3.5 3.1 2.8 2.5 2.1 1.8
    Chemical shift δ (ppm) 4.26 3.4 3.05 2.68 2.16 0.23 0

    As can be seen from the data, as the electronegativity of X increases the chemical shift, δ increases. This is an effect of the halide atom pulling the electron density away from the methyl group. This exposes the nuclei of both the C and H atoms, "deshielding" the nuclei and shifting the peak downfield.

    The effects are cumulative so the presence of more electron withdrawing groups will produce a greater deshielding and therefore a larger chemical shift, i.e.

    Compound CH4 CH3Cl CH2Cl2 CHCl3
    δ (ppm) 0.23 3.05 5.30 7.27

    These inductive effects are not only felt by the immediately adjacent atoms, but the deshielding can occur further down the chain, i.e.

    NMR signal -CH2-CH2-CH2Br
    δ (ppm) 1.25   1.69   3.30

    Magnetic Anisotropy: π Electron Effects

    The π electrons in a compound, when placed in a magnetic field, will move and generate their own magnetic field. The new magnetic field will have an effect on the shielding of atoms within the field. The best example of this is benzene (see the figure below).

    magnetic anisotropy of benzene

    This effect is common for any atoms near a π bond, i.e.

    Proton Type Effect Chemical shift (ppm)
    C6H5-H highly deshielded 6.5 - 8
    C=C-H deshielded 4.5 - 6
    C≡C-H shielded* ~2.5
    O=C-H very highly deshielded 9 - 10
    * the acetylene H is shielded due to its location relative to the π system

    Hydrogen Bonding

    Protons that are involved in hydrogen bonding (i.e.-OH or -NH) are usually observed over a wide range of chemical shifts. This is due to the deshielding that occurs in the hydrogen bond. Since hydrogen bonds are dynamic, constantly forming, breaking and forming again, there will be a wide range of hydrogen bonds strengths and consequently a wide range of deshielding. This as well as solvation effects, acidity, concentration and temperature make it very difficult to predict the chemical shifts for these atoms.

    nmr-8.png

    Experimentally -OH and -NH can be identified by carrying out a simple D2O exchange experiment since these  protons are exchangeable.

    • run the normal H-NMR experiment on your sample
    • add a few drops of D2O
    • re-run the H-NMR experiment
    • compare the two spectra and look for peaks that have "disappeared"

    Table of chemical shifts

    Exercise

    Questions

    Q13.3.1

    The following peaks were from a H1 NMR spectra from a 400 MHz spectrometer. Convert to δ units

    A. CHCl3 1451 Hz

    B. CH3Cl 610 Hz

    C. CH3OH 693 Hz

    D. CH2Cl2 1060 Hz

    Q13.3.2

    Butan-2-one shows a chemical shift around 2.1 on a 300 MHz spectrometer in the H1 NMR spectrum.

    A. How far downfield is this peak from TMS in Hz?

    B. If the spectrum was done with a 400 MHz instrument, would a different chemical shift be seen?

    C. On this new 400 MHz spectrum, what would be the difference in Hz from the chemical shift and TMS?

    Solutions

    S13.3.1

    A. 3.627 ppm

    B. 1.525 ppm

    C. 1.732 ppm

    D. 2.65 ppm

    S13.3.2

    A. Since TMS is at 0 δ = 0 Hz for reference, the difference between the two would be 630 Hz

    B. No not a different chemical shift, but a different frequency would be seen, 840 Hz

    C. 840 Hz