20.3: Unlike heat, Entropy is a State Function
- Page ID
- 13717
Circular integrals
Because entropy is a state function, it integrates to zero over any circular path going back to initial conditions, just like \(U\) and \(H\):
\[\oint dS =0 \nonumber \]
\[\oint dH =0 \nonumber \]
\[\oint dU =0 \nonumber \]
As discussed previously, we can use this fact to revisit the isotherm + isochore + adiabat circular path (Figure 20.3.1 ).
Along adiabat B and isochore C:
- There is no heat transfer along adiabat B:
\[q_{rev,B} = 0 \nonumber \]
- There is no work along isochore C:
\[\delta w=0 \nonumber \]
- But the temperature changes from \(T_2\) back to \(T_1\). This requires heat:
\[q_{rev,C}=C_V\Delta T \nonumber \]
Along the isotherm A:
- We have seen that
\[q_{rev,A} = nRT \ln \dfrac{V_2}{V_1} \nonumber \]
The quantities qrev,A, qrev,B, and qrev,C are not the same, which once again underlines that heat is a path function. How about entropy?
First, consider the combined paths of B and C:
\[q_{rev,B+C} = \int _{T_2}^{T_1} C_v dT \nonumber \]
\[\int dS_{B+C} = \int \dfrac{dq_{rev,B+C}}{T} = \int _{T_2}^{T_1} \dfrac{C_v}{T} dT \nonumber \]
We had seen this integral before from Section 19-6, albeit from \(T_1\) to \(T_2\):
\[\Delta S_{B+C} = nR\ln \dfrac{V_2}{V_1} \label{19.21} \]
(Notice sign in Equation \ref{19.21} is positive)
Along the isotherm A:
\[q_{rev,A} = nRT \ln\frac{V_2}{V_1} \nonumber \]
\(T\) is a constant so we can just divide \(q_{rec,A}\) by \(T\) to get \(\Delta S_A\):
\[\Delta S_A = nR\ln \dfrac{V_2}{V_1} \nonumber \]
We took two different paths to get start and end at the same points. Both paths had the same change in entropy. Clearly entropy is a state function while \(q_{rev}\) is not.